Edwards' Little Ant, a terrestrial dry fly pattern for trout
An ant imitation that is easy to tie, floats like a cork and looks a lot like the real thing.
An oldie pattern from GFF
By Martin Joergensen
Foam and bristles.
Get out your ant repellent!
The proper positioning and angles of the legs are a key to the imitative quality of the pattern.
|
|
Ant patterns are usually a bit of foam and a chaotic dry fly hackle. But why not tie it more imitative? It's quite easy. This pattern was originally shown to me by Oliver Edwards. Oliver's hallmark is indeed very accurate imitations, but usually his patterns are quite complex and hard to tie. But not this one. It takes about a couple of minutes to tie - and a minute or so to arrange the legs - the key to the pattern's fine appearance.
All synthetic
The materials for the ant are few and simple - and all synthetic. For the body we use foam of the closed cell craft foam type and the legs and antennae are single, synthetic bristles from a broom or paint brush. A few years back I cut a piece of a new, small broom... much to the regret of my wife. But it supplied enough leg material for lifetime worth of ants and beetles.
The position of the legs is an important factor in getting the imitation convincing. I don't doubt that a trout will hit an ant whose legs and antennae are straight as a ruler - or chaotic like the dry fly hackle. But it adds greatly to the appearance of the pattern if the legs are bent as shown.
This is easily done with a pair of thin pliers or tweezers. Oliver Edwards heats them before the maneouvre, but I have used cold tweezers for all my ants, and that works fine.
Bend each leg as shown and double it over, giving it a hard squeeze to set the bend properly. Then open the bend to a proper angle and it will sit there for a long while. Getting the legs symmetrical can be tricky, but with a little practise you will get some fine results.
Materials
Hook
|
Up eye dry fly hook. Sizes 12-18
|
Thread
|
8/0, color to match body material
|
Body
|
Thin strip of black, grey, cinnamon or yellow craft foam
|
Legs and antennae
|
Synthetic, brush or broom hairs, color to match body material
|
Ventral and dorsal veiw of the same Edwards' Little Ant.
Above you see a similar view of a small beetle tied using the same materials and technique.
A generic foam beetle tied as the ant - with a few modifications.
|
|
Tying instructions:
- Start the thread on the rear section of the hook
- Cut a 2 centimeters (approx 1') narrow section of craft foam
- A width of 2 millimeters (less than 1/10 of an inch) is fine
- You might need to slice the foam even thinner than it is from the start
- Tie in the foam centrally on the hook shank
- Tie it down in almost the full shank length
- Prepare four bristles for legs and antennae
- Tie three sets perpenducular to the shank, equally distributed on the middle third of the shank
- Use a few criss-cross wraps to set each leg set
- Tie in the last bristle on the front part of the body
- Fold back the foam and tie down, pressing out all the air
- It should form a small head over the antennae and a larger abdomen behind the last set of legs
- Cut surplus
- Whip finish behind the head and varnish
- Bend the legs as shown above
The technique used for this ant pattern can be used for other terrestrials too. A beetle is very easy to make using the same materials.
The beetle is basically tied in the same way, but with the omission of the antennae. The major difference between this little beetle and the ant is the abdomen. By folding the rear part of the foam over the two rear set of legs and tying it down there, you imitate the larger abdomen of the typical beetle.
Again the legs make a difference. The beetle will basically do with two sets pointing rearwards and one set pointing to the front. Each leg should have a knee with a slight bend and the beetle will be ready to join the ant and crawl off...
| User comments |  |
Did you find the above interesting? | People who looked at the above also looked at:
Steve Schweitzer is at it again. He just can't stay away from th...
The two spots in the name of this fly comes from the bait, which...
Section: The best fly patterns from all over the globe
Section: Improve your fly tying and learn new, neat tricks with ...
A jigging fly for almost any predatory fish originated by Bob Po...
|
These other stories related to "Foam" might also interest you:The Floating ShrimpFloater: One of Hanafi Saleh's patterns is the "HS Floating Shrimp" which is very suitable for fishing just above the bottomweeds, or just above the bottom without the risk of getting snagged at underwater obstacles.
Go to the story  The Locofoam StoryIls sont fou: Harrison Steeve's story about a brand new foam material for terrestrials and many other flies. "You guys are crazy to spend so much time messing around with that loco foam." Needless to say the name stuck. Read the whole story here.
Go to the story
More about Foam |
A few random articles for your entertainment
|
| 
Submitted July 20th 2007
The beatles cool looks the part, of to tie some now, i love tying flies out of foam and the many ranges of colours, makes some of the patterns easier to adapt for terrestrials. Thanks Jan